Nissan Versa Disc Brake Rotor and Hub Assembly Kit in US

On Nissan Versa vehicles where the brake rotor and wheel hub share a single integrated casting, a rotor and hub assembly kit is the most complete way to restore full brake corner performance on your Versa. When a seized caliper damages the Versa rotor surface, or when hub bearing noise develops alongside worn rotors on your Nissan Versa, all friction and hub components require replacement simultaneously.

Why the Nissan Versa Needs a Kit Rather Than Individual Components

New brake pads on your Nissan Versa must bed into the rotor surface during the first 200 to 300 kilometres. When the pad compound and rotor surface finish are mismatched on the Nissan Versa, bedding-in is inconsistent, producing noise, vibration, and uneven wear. A GeoBrakes kit pairs pad and rotor from the same specification set for the Nissan Versa, ensuring the smoothest possible break-in and the most consistent long-term friction performance on your Versa.

What Is Included in the Nissan Versa Rotor and Hub Assembly Kit

The kit for your Nissan Versa includes the integrated rotor and hub assembly at OEM specification for the Versa hub geometry, brake pads in ceramic or semi-metallic formulation matched to the Nissan Versa rotor surface finish, caliper hardware with slide pins and anti-rattle clips for correct caliper operation on your Versa, and rotor mounting hardware where required by the Nissan Versa application.

Signs Your Nissan Versa Rotor and Hub Assembly Kit Is Due

• Versa rotor surfaces scored, deeply grooved, or below minimum thickness specification
• Wheel bearing noise on your Nissan Versa, humming or rumbling changing pitch during cornering
• Excessive wheel play or looseness on the Versa detected during a manual push-pull inspection
• Steering wheel or floor vibration on your Nissan Versa at highway speed from rotor runout
• ABS warning light on your Versa caused by hub bearing affecting the wheel speed sensor air gap
• Damaged or stripped wheel studs on the Nissan Versa requiring hub replacement alongside rotor service

Why GeoBrakes for the Nissan Versa Rotor and Hub Assembly Kit

Rotor and hub assemblies for the Nissan Versa are among the most vehicle-specific brake components in the catalogue. Hub bolt circle, rotor diameter, hub bore, and the wheel speed sensor interface are all specific to the Nissan Versa. Our vehicle selector confirms the correct kit for the Nissan Versa left and right positions before purchase, with full manufacturer warranty coverage across all included components for your Versa.

Frequently Asked Questions - Nissan Versa Rotor and Hub Assembly Kits

Should I replace rotor and hub assembly kits on both sides of my Nissan Versa?

Yes. Replacing both left and right on the same axle of your Nissan Versa ensures balanced braking, even wear, and consistent vehicle handling. Both assemblies have experienced the same service conditions on the Versa and are at a comparable stage of wear.

Can I use the pads from the kit with my existing Nissan Versa rotors?

While the pads will physically fit existing Versa rotors, it is strongly recommended to install new pads on a new rotor surface. Worn Nissan Versa rotors have an uneven profile that prevents new pads from bedding in correctly, producing vibration, noise, and accelerated pad wear on your Versa.

Does the Nissan Versa kit include the wheel bearing?

This depends on the specific Nissan Versa application. On many Versa front-wheel-drive platforms, the wheel bearing is a separate component not included in the rotor-hub casting. Use the GeoBrakes vehicle selector to confirm what is included in the kit for your Nissan Versa.