Nissan Kicks Disc Brake Rotor and Hub Assembly Kit in US

On Nissan Kicks vehicles where the brake rotor and wheel hub share a single integrated casting, a rotor and hub assembly kit is the most complete way to restore full brake corner performance on your Kicks. When a seized caliper damages the Kicks rotor surface, or when hub bearing noise develops alongside worn rotors on your Nissan Kicks, all friction and hub components require replacement simultaneously.

Why the Nissan Kicks Needs a Kit Rather Than Individual Components

New brake pads on your Nissan Kicks must bed into the rotor surface during the first 200 to 300 kilometres. When the pad compound and rotor surface finish are mismatched on the Nissan Kicks, bedding-in is inconsistent, producing noise, vibration, and uneven wear. A GeoBrakes kit pairs pad and rotor from the same specification set for the Nissan Kicks, ensuring the smoothest possible break-in and the most consistent long-term friction performance on your Kicks.

What Is Included in the Nissan Kicks Rotor and Hub Assembly Kit

The kit for your Nissan Kicks includes the integrated rotor and hub assembly at OEM specification for the Kicks hub geometry, brake pads in ceramic or semi-metallic formulation matched to the Nissan Kicks rotor surface finish, caliper hardware with slide pins and anti-rattle clips for correct caliper operation on your Kicks, and rotor mounting hardware where required by the Nissan Kicks application.

Signs Your Nissan Kicks Rotor and Hub Assembly Kit Is Due

• Kicks rotor surfaces scored, deeply grooved, or below minimum thickness specification
• Wheel bearing noise on your Nissan Kicks, humming or rumbling changing pitch during cornering
• Excessive wheel play or looseness on the Kicks detected during a manual push-pull inspection
• Steering wheel or floor vibration on your Nissan Kicks at highway speed from rotor runout
• ABS warning light on your Kicks caused by hub bearing affecting the wheel speed sensor air gap
• Damaged or stripped wheel studs on the Nissan Kicks requiring hub replacement alongside rotor service

Why GeoBrakes for the Nissan Kicks Rotor and Hub Assembly Kit

Rotor and hub assemblies for the Nissan Kicks are among the most vehicle-specific brake components in the catalogue. Hub bolt circle, rotor diameter, hub bore, and the wheel speed sensor interface are all specific to the Nissan Kicks. Our vehicle selector confirms the correct kit for the Nissan Kicks left and right positions before purchase, with full manufacturer warranty coverage across all included components for your Kicks.

Frequently Asked Questions - Nissan Kicks Rotor and Hub Assembly Kits

Should I replace rotor and hub assembly kits on both sides of my Nissan Kicks?

Yes. Replacing both left and right on the same axle of your Nissan Kicks ensures balanced braking, even wear, and consistent vehicle handling. Both assemblies have experienced the same service conditions on the Kicks and are at a comparable stage of wear.

Can I use the pads from the kit with my existing Nissan Kicks rotors?

While the pads will physically fit existing Kicks rotors, it is strongly recommended to install new pads on a new rotor surface. Worn Nissan Kicks rotors have an uneven profile that prevents new pads from bedding in correctly, producing vibration, noise, and accelerated pad wear on your Kicks.

Does the Nissan Kicks kit include the wheel bearing?

This depends on the specific Nissan Kicks application. On many Kicks front-wheel-drive platforms, the wheel bearing is a separate component not included in the rotor-hub casting. Use the GeoBrakes vehicle selector to confirm what is included in the kit for your Nissan Kicks.