Mercedes Benz S320 Brake Pad Wear Sensor in US

A disc brake pad wear sensor on the Mercedes Benz S320 is your vehicle's advance warning system for brake pad replacement. It eliminates the need to rely on audible squealing from your S320 to know your pads are getting thin, instead triggering a dashboard warning light at a preset minimum thickness on the Mercedes Benz S320, giving you time to plan the replacement before the pads wear through to the metal backing plate. Replacing a triggered sensor with every S320 pad change is the only way to keep that early-warning system working for the next service interval.

How the Brake Pad Wear Sensor Works on the Mercedes Benz S320

The wear sensor on the Mercedes Benz S320 is a small probe embedded in or clipped to the brake pad. When the S320 pad wears down to the replacement threshold, the probe contacts the rotor surface. This contact creates a circuit change that signals the Mercedes Benz S320 ABS or brake control module, illuminating the brake warning light. Once the probe on the Mercedes Benz S320 has contacted the rotor, it is destroyed and cannot be reused. It is a single-use component by design on the S320.

Why Replace the Wear Sensor at Every Mercedes Benz S320 Pad Change

Installing fresh brake pads on the Mercedes Benz S320 without fitting a new wear sensor defeats the entire purpose of having a brake monitoring system on your S320. A previously triggered sensor probe is worn through and has no remaining material to detect the next set of S320 pads wearing down. From day one of the new Mercedes Benz S320 brake pads, the warning system is non-functional without a new sensor.

Signs the Wear Sensor on Your Mercedes Benz S320 Needs Replacing

• Brake warning light staying on your Mercedes Benz S320 after new pads have been fitted
• Intermittent brake warning light on your S320 that clears and returns without obvious cause
• Visible wear notch or contact mark on the Mercedes Benz S320 sensor probe tip
• OBD fault codes on your S320 referencing the brake pad monitoring circuit

Why GeoBrakes for the Mercedes Benz S320 Brake Pad Wear Sensor

Wear sensor compatibility for the Mercedes Benz S320 is more exacting than most brake parts. The probe length, contact resistance specification, and connector design must all match the S320 brake monitoring circuit precisely. A wrong sensor triggers Mercedes Benz S320 warnings at the wrong pad thickness, or not at all. Every sensor in the GeoBrakes catalogue is sourced to original equipment probe and connector specifications for the Mercedes Benz S320, with front and rear positions listed separately.

Frequently Asked Questions - Mercedes Benz S320 Brake Pad Wear Sensor

Do I need to replace the brake pad wear sensor every time I change pads on my Mercedes Benz S320?

Yes, on Mercedes Benz S320 vehicles equipped with electronic wear sensors. The sensor probe on your S320 is a single-use component. Once it has contacted the rotor and triggered the S320 warning light, the probe is consumed. Always replace the Mercedes Benz S320 sensor during every pad change.

Does my Mercedes Benz S320 have electronic brake pad wear sensors?

Many vehicles use a mechanical wear indicator instead of electronic sensors. Check your Mercedes Benz S320 owner's manual or use the GeoBrakes vehicle selector to confirm whether your S320 uses an electronic pad monitoring system.

Can a faulty wear sensor keep the brake warning light on my Mercedes Benz S320 on after new pads are installed?

Yes. If the Mercedes Benz S320 wear sensor from a previous brake service was not replaced, or if the probe has been damaged on your S320, the brake warning light will remain on even with new pads. Replacing the S320 sensor will clear the fault and restore normal operation.