Honda Civic Disc Brake Rotor and Hub Assembly Kit in US

On Honda Civic vehicles where the brake rotor and wheel hub share a single integrated casting, a rotor and hub assembly kit is the most complete way to restore full brake corner performance on your Civic. When a seized caliper damages the Civic rotor surface, or when hub bearing noise develops alongside worn rotors on your Honda Civic, all friction and hub components require replacement simultaneously.

Why the Honda Civic Needs a Kit Rather Than Individual Components

New brake pads on your Honda Civic must bed into the rotor surface during the first 200 to 300 kilometres. When the pad compound and rotor surface finish are mismatched on the Honda Civic, bedding-in is inconsistent, producing noise, vibration, and uneven wear. A GeoBrakes kit pairs pad and rotor from the same specification set for the Honda Civic, ensuring the smoothest possible break-in and the most consistent long-term friction performance on your Civic.

What Is Included in the Honda Civic Rotor and Hub Assembly Kit

The kit for your Honda Civic includes the integrated rotor and hub assembly at OEM specification for the Civic hub geometry, brake pads in ceramic or semi-metallic formulation matched to the Honda Civic rotor surface finish, caliper hardware with slide pins and anti-rattle clips for correct caliper operation on your Civic, and rotor mounting hardware where required by the Honda Civic application.

Signs Your Honda Civic Rotor and Hub Assembly Kit Is Due

• Civic rotor surfaces scored, deeply grooved, or below minimum thickness specification
• Wheel bearing noise on your Honda Civic, humming or rumbling changing pitch during cornering
• Excessive wheel play or looseness on the Civic detected during a manual push-pull inspection
• Steering wheel or floor vibration on your Honda Civic at highway speed from rotor runout
• ABS warning light on your Civic caused by hub bearing affecting the wheel speed sensor air gap
• Damaged or stripped wheel studs on the Honda Civic requiring hub replacement alongside rotor service

Why GeoBrakes for the Honda Civic Rotor and Hub Assembly Kit

Rotor and hub assemblies for the Honda Civic are among the most vehicle-specific brake components in the catalogue. Hub bolt circle, rotor diameter, hub bore, and the wheel speed sensor interface are all specific to the Honda Civic. Our vehicle selector confirms the correct kit for the Honda Civic left and right positions before purchase, with full manufacturer warranty coverage across all included components for your Civic.

Frequently Asked Questions - Honda Civic Rotor and Hub Assembly Kits

Should I replace rotor and hub assembly kits on both sides of my Honda Civic?

Yes. Replacing both left and right on the same axle of your Honda Civic ensures balanced braking, even wear, and consistent vehicle handling. Both assemblies have experienced the same service conditions on the Civic and are at a comparable stage of wear.

Can I use the pads from the kit with my existing Honda Civic rotors?

While the pads will physically fit existing Civic rotors, it is strongly recommended to install new pads on a new rotor surface. Worn Honda Civic rotors have an uneven profile that prevents new pads from bedding in correctly, producing vibration, noise, and accelerated pad wear on your Civic.

Does the Honda Civic kit include the wheel bearing?

This depends on the specific Honda Civic application. On many Civic front-wheel-drive platforms, the wheel bearing is a separate component not included in the rotor-hub casting. Use the GeoBrakes vehicle selector to confirm what is included in the kit for your Honda Civic.