Dodge Ram 1500 Disc Brake Rotor and Hub Assembly Kit in US

On Dodge Ram 1500 vehicles where the brake rotor and wheel hub share a single integrated casting, a rotor and hub assembly kit is the most complete way to restore full brake corner performance on your Ram 1500. When a seized caliper damages the Ram 1500 rotor surface, or when hub bearing noise develops alongside worn rotors on your Dodge Ram 1500, all friction and hub components require replacement simultaneously.

Why the Dodge Ram 1500 Needs a Kit Rather Than Individual Components

New brake pads on your Dodge Ram 1500 must bed into the rotor surface during the first 200 to 300 kilometres. When the pad compound and rotor surface finish are mismatched on the Dodge Ram 1500, bedding-in is inconsistent, producing noise, vibration, and uneven wear. A GeoBrakes kit pairs pad and rotor from the same specification set for the Dodge Ram 1500, ensuring the smoothest possible break-in and the most consistent long-term friction performance on your Ram 1500.

What Is Included in the Dodge Ram 1500 Rotor and Hub Assembly Kit

The kit for your Dodge Ram 1500 includes the integrated rotor and hub assembly at OEM specification for the Ram 1500 hub geometry, brake pads in ceramic or semi-metallic formulation matched to the Dodge Ram 1500 rotor surface finish, caliper hardware with slide pins and anti-rattle clips for correct caliper operation on your Ram 1500, and rotor mounting hardware where required by the Dodge Ram 1500 application.

Signs Your Dodge Ram 1500 Rotor and Hub Assembly Kit Is Due

• Ram 1500 rotor surfaces scored, deeply grooved, or below minimum thickness specification
• Wheel bearing noise on your Dodge Ram 1500, humming or rumbling changing pitch during cornering
• Excessive wheel play or looseness on the Ram 1500 detected during a manual push-pull inspection
• Steering wheel or floor vibration on your Dodge Ram 1500 at highway speed from rotor runout
• ABS warning light on your Ram 1500 caused by hub bearing affecting the wheel speed sensor air gap
• Damaged or stripped wheel studs on the Dodge Ram 1500 requiring hub replacement alongside rotor service

Why GeoBrakes for the Dodge Ram 1500 Rotor and Hub Assembly Kit

Rotor and hub assemblies for the Dodge Ram 1500 are among the most vehicle-specific brake components in the catalogue. Hub bolt circle, rotor diameter, hub bore, and the wheel speed sensor interface are all specific to the Dodge Ram 1500. Our vehicle selector confirms the correct kit for the Dodge Ram 1500 left and right positions before purchase, with full manufacturer warranty coverage across all included components for your Ram 1500.

Frequently Asked Questions - Dodge Ram 1500 Rotor and Hub Assembly Kits

Should I replace rotor and hub assembly kits on both sides of my Dodge Ram 1500?

Yes. Replacing both left and right on the same axle of your Dodge Ram 1500 ensures balanced braking, even wear, and consistent vehicle handling. Both assemblies have experienced the same service conditions on the Ram 1500 and are at a comparable stage of wear.

Can I use the pads from the kit with my existing Dodge Ram 1500 rotors?

While the pads will physically fit existing Ram 1500 rotors, it is strongly recommended to install new pads on a new rotor surface. Worn Dodge Ram 1500 rotors have an uneven profile that prevents new pads from bedding in correctly, producing vibration, noise, and accelerated pad wear on your Ram 1500.

Does the Dodge Ram 1500 kit include the wheel bearing?

This depends on the specific Dodge Ram 1500 application. On many Ram 1500 front-wheel-drive platforms, the wheel bearing is a separate component not included in the rotor-hub casting. Use the GeoBrakes vehicle selector to confirm what is included in the kit for your Dodge Ram 1500.