Chrysler Voyager Brake Drum Kit in US

A brake drum kit for the Chrysler Voyager addresses the most common brake service shortcut: replacing shoes on a worn Voyager drum, or fitting new drums with glazed, worn shoes. Either combination prevents correct break-in on the Chrysler Voyager. New shoes have a specific arc radius that must contact a fresh drum surface across the full lining width on your Voyager. A GeoBrakes drum kit eliminates that incompatibility by delivering matched drums and shoes confirmed for your Chrysler Voyager in a single order.

What Is Included in the Chrysler Voyager Brake Drum Kit

The kit for your Chrysler Voyager includes OEM-spec cast-iron brake drums at the correct inner diameter for the Voyager for both left and right rear wheels, drum brake shoes with OEM-grade friction lining matched to the Chrysler Voyager drum bore and wheel cylinder specification, a brake hardware kit with return springs, hold-down hardware, and self-adjusters specific to the Voyager, and drum retaining hardware where required by the Chrysler Voyager application.

Why American Conditions Make a Full Kit the Right Call for Your Chrysler Voyager

Road salt and freeze-thaw cycles deteriorate every component in the Chrysler Voyager drum brake system over the same service interval. By the time a Voyager drum is worn, the shoes are typically at or near minimum thickness, the hardware is corroded, and the wheel cylinder boots are deteriorating on your Chrysler Voyager. Replacing drums and shoes alone while leaving worn springs and seized adjusters on the Voyager produces a service that underperforms within months.

Signs the Brake Drum Kit on Your Chrysler Voyager Is Due

• Rear brake pulsation or grabbing on your Chrysler Voyager during stops, out-of-round drum bore
• Grinding or scraping from the Voyager rear axle with the parking brake fully released
• Voyager drum inner surface scored or worn to maximum allowable diameter on inspection
• Friction lining at or below 1.5mm on your Chrysler Voyager visible during drum removal
• Parking brake on your Voyager requiring excessive travel before holding on a slope
• Chrysler Voyager pulling to one side under braking, asymmetric drum or shoe condition

Why GeoBrakes for the Chrysler Voyager Brake Drum Kit

Drum and shoe arc radius must match exactly for correct contact geometry on the Chrysler Voyager. An incorrect drum diameter or wrong-spec shoe lining for the Voyager produces immediate uneven wear and noise. Every kit in the GeoBrakes catalogue is assembled for the Chrysler Voyager, drum diameter, shoe arc, and hardware spring rates all confirmed as a matched set specific to the Voyager.

Frequently Asked Questions - Chrysler Voyager Brake Drum Kits

How do I know if I need a basic or full-service kit for my Chrysler Voyager?

A basic kit for the Chrysler Voyager is appropriate when the wheel cylinders have been recently replaced and show no signs of leaking. A full-service kit is the stronger choice during a high-mileage Voyager overhaul, particularly on American Chrysler Voyager vehicles with significant winter salt exposure.

Should I replace drum kits on both rear wheels of my Chrysler Voyager at the same time?

Yes. Always replace drum brake components on the Chrysler Voyager as an axle set, both left and right rear, to maintain balanced braking force. Drums and shoes at different wear stages on the Voyager create uneven rear braking that pulls the vehicle to one side.

Can I install a brake drum kit on my Chrysler Voyager myself?

Rear drum brake service on the Chrysler Voyager is a moderately advanced DIY task. It requires removing the drum, dismantling the shoe assembly on the Voyager, correctly routing return springs, and adjusting shoes to the correct drum clearance. A service manual specific to the Chrysler Voyager is essential.